Garden Station

As mentioned on a previous post here are a few more details on the garden station project.   The aim of this project is to build a simple garden watering controller.  As part of this I also wanted to get some PCB’s made to try out getting some made and a sent to me.   I used seeed studio to get the PCBs made and they came out great (although they do take about 4 week to get).

The basic premiss of the garden station is that there are 5 watering sensors, a temperature sensor, 5 servos (used to control water), 6 LEDs, 3 buttons and an LCD display for setup.   I’ve also added ICSP with 2 extra pins to allow for ethernet or SD card expansion via SPI.  On the final version which is not yet built there is also a MOSFET to switch on and off the LCD back light.  I’m building a few of these boards and will probably use them as general purpose control boards for other projects.

The circuit diagram, PCB layout and code are available from github.

I’m still in the middle of this project but have a working prototype from the original through hole PCB:-


As you can see there is some hacks on the board around the shift registers as there were some error on the original circuit (confusion of Eagle’s 595 pin names..).

The working of the circuit is reasonable simple.   6 of the analogue pins are used to provide the input for the moisture sensors and temperature.  I’m using 2 nails which there are plenty of internet articles about.   These go to the screw connectors at the bottom right.

There are 5 PWM outputs to control the servo valves.  These are the bottom middle connectors on the picture above.  I use a small break out board to connect the servos which are all located together.   My original plan was to run long wires to near the plants but in the end I decided to keep them all next to the board (its currently all in an Ice Cream tub…).   The servo are connected to some Pope valves which connect to small 4mm hoses.   These are attached together with a hot glue gun and some paper clips agh the moment, although I’m getting a friend to 3D print some proper brackets:-


I’m also looking to direct drive via a cog when the mounting bracket has been made.

Display and Buttons

At the top of the board there are some connection for the display and the input buttons.   These are not the same as a standard display pinout on the original prototype (hence the wire soldered straight in).   On the SMD version theses have been fixed.   The display is controlled via the first shift register in order to reduce the number of pins needed.


The second shift register controls the LED’s on the board and uses the overflow from the first (hence no extra pins needed).  The last two outputs on the second shift register are used to control the backlight and provide the power for the moisture sensor in the SMD version.

Finally there is a set of 8 pins used for ICSP (6 pin with the 2 top pins being extra data output intended for SPI ethernet or SD card).

I’m still testing but will post some video of the prototype running in the future.   I’ll also be ordering all the parts for the SMD version in the next week so will post the details when thats done!

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s